TimerCommander™
TimerCommander is a small application for timer control of the Live-FX™
LiveController Pro, Live \AC-4 or the Live-FX ScentPlayer. This software comes free with
the purchase of one of the mention controllers. The program features a rich
toolset of editable fields & setable timers, Drag n' Drop FX tabs & even looping options.
Great for
businesses, home aromatherapy sessions & parties. TimerCommander has the
ability to run like an effect "jukebox" where you can interactively change
scents or other FX while it is running or put the next one in cue without effecting
other running timers. To scent very large areas, you can use it for the control
of single fans with scent EFX strips. For a timer solution with more then
6 channels,
see the LiveTrax software which has more advanced timings & channel options.
The release of this software will be April 15, 2010
Requirements: |
 |
|||
| Features: | ||||
| An easy to use interface that allows you to control the on/off state for each slot in the interface (4 AC lines if using LiveAC-4 and 8 scent slots if using scentplayer-8). Each time slot, (of the 6 available), can be assigned a labeled to help identify what you are triggering. Label tabs are then Drag n Dropable. Labels light up their name with respective line number in green when in "ready" status. |
 |
|||
 |
All timings
can be saved and re-loaded and labels can be
changed or renamed by launching the LiveCommander or
ScentManger Tool (mode depending). This feature allows you to record the names of new
channels. When you save a configuration here, all other
software that uses Scents or Live-FX controllers will share the settings for seamless
integration. |
|||
|
Looping
sequences are also possible. When looping is set. your fifth
time slot's end will start the first slot. The program will
continue to loop until you stop the sequence. |
 |
|||
 |
You can perform "scent
skipping" of an active scent by pressing the next arrow to the right of
each slot. This will make the slot's active field (that is green when
set) to go red and will immediately move onto the next. The previous
counter will set to :01 so it will continue to skip if you are in a
session that is looping. To make it not skip on the next pass, drag over
a new scent choice so it turns back to green. |
|||
| TimerCommander has 2 modes, Scent & Other. When set to "Other", you can turn on AC or DC lines, allowing trigger of lights, misters, wind fans, shakers or any other kind of effect where timed events are required. |
 |
|||
 |
|
Coming Soon - TimerCommander's external trigger features allows you to start a sequence when an external trigger is detected (requires LiveController Pro). This features allows you start from a motion sensor or floor mat). Checkbox allows you to enable/disable the feature |
||
|
|
||||
|
||||
